How bad of an idea is my friend's cheap throttle lock?

How many times do you get out and ride? How many times have you cleaned your bike? What road trips have you had to cancel? I was going from Melbourne to the Atherton Tablelands ..... looks like that...

Looked so good but definitely was a bad idea. The lights kept turning on even after I made sure they were off and killed my battery ...

8 days till i jump out of a airplane and soar like a bird or fall like a rock...

¡ ¡ ¡ ! ! !...

You’ll need a Philips screw driver, some contact cleaner, rags and about half an hour. Also helpful is an old tooth brush and a flat head screw driver. First remove the two screws under the...

I've always been attracted to motorcycles that were fast and high-tech and futuristic. This little beauty defies all of those categories. It isn't a sense of nostalgia... I was 8 years old when the GB...

Although haven't had someone do this maliciously (yet) but find it pretty annoying that someone can just pull your keys out of the ignition willy nlly and kill my bike while I'm riding. know a couple...

I just removed and drained the tank of an Kawasaki zx6r that had been sitting for 10 years. The fuel pump was copper stained, there was loads and loads of sediment, it feels corroded around where the...

-Front wheel, brake caliper and fork guards off -Loosen top triple clamp bolts and break the caps loose -Remove forks and unscrew the caps the rest of the way -Pull down the fork spring and insert...

Clutch fluid is corrosive and will damage paint. Avoid contact with eyes and skin. In case of accidental contact, wash thoroughly with water. Fill the reservoir with specified fluid taken from a...

Remove the cap to expose the bleed valve (3). Connect a clutch circuit bleeding tool to the clutch slave cylinder bleed valve (3). Remove the cover (1) with the membrane from the clutch fluid reservo...

Can't tell if the tank itself is actually flaking or if it's a coat that's flaking off? What would you recommend doing from here?...

This is a step by step video including torque specs....