Fork Seals arrived

Seals working fine. Took a 6 mile test ride today....

First time to do fork seals. Only took 3 hours. It was not as hard as I thought. Ready to ride....

First step was to build the dust excluder assenblies. This is really just installing seals and O rings. Apparently some time during '71, there were two seal designs. One was a conventional pressed-...

So far, my impression is favourable. #divvymanstravels #yamaha #xj900sdiversion #diversionxj900s #motorcyclemaintenance...

Enjoying a nice sunday ride with a friend 80 miles from the garage and the L/H fork seal gives out on me, hydraulic oil cover my leg from the knee down, all over the engine primary cover and even the...

I’ll be riding other bikes for a bit. I’m due for 20k service and my fork seals are gone. I’m told a rebuild is normal at 15k so I guess I did good going this long. Gonna be $1200 all said and done so...

-Front wheel, brake caliper and fork guards off -Loosen top triple clamp bolts and break the caps loose -Remove forks and unscrew the caps the rest of the way -Pull down the fork spring and insert...

I've been working slowly on the forks for the past few weeks. A lot of distractions lately, but things are still moving. From an appearance point of view, I knew I'd be repainting parts, but the cur...

Replacing the fork seals on my bike and I can't get the shaft to come out. I've put the forks in a clamp and violently pulled to no avail. The other one came apart just fine. Any ideas? 08' CBR 600RR...

I was ready to mount the forks on the frame, and, in an uncharacteristic flash of foresight, I realized that assembling the entire bike up on the work table may not be the smartest plan.  Do...

I was ready to mount the forks on the frame, and, in an uncharacteristic flash of foresight, I realized that assembling the entire bike up on the work table may not be the smartest plan.  Do...

Front fender will be held in place using brackets of the existing bottom fork metalwork. The original KTM Duke fender was a close fitting hugger that would look terrible (and won't fit). I should be a...