Stator repair…

So I built a ramp/platform to work on the bike. No lift - just needed it high enough to work on the bike without laying on the floor. Opening for an oil pan to drop the oil, struts across every point...

I'm so close to finnishing this project now I need to ride ...

May of taken the long way ...

Finally got the paint fixed and got new mirrors installed. Who would have thought that you could fix a Yamaha with Honda parts....

Recently bike decided to stop running, found out I'm not getting fuel. (found issue) New fuel pump, filter, and a fancy overpriced diagnostic reader adapter have finally showed up. What sort of Blackf...

Video will be up tonight or tomorrow stay tuned!...

What do you guys think?...

Wife dropped it again. Damaged wind screen, rear brake controls, front brake controls and handlebars. I guess now is the chance to make some aftermarket improvements....

Scrapes on your black plastic fairings? Try electrical tape! :D...

Its been a while since ive posted on here. not had much time to work on the project bikes for a while, as im trying to move house. anyway, as the sun has shown its face again, my lovely little R6 ha...

Managed to get her back out using tack welding washers and a pull hammer. Next up a bit of filler to smoothen her out....

Hello guys am having a cbr1000rr 2004 ,advise how i can sort stator coil failure..the bike is not charging...

Any ideas on how to fix this kind of scratch? thought of sanding it down (or even cutting the rough edges with razor blade) and later polish? Is this the best that can be done? Material is almost like...

As it should be Enduro, the bike is dirty, the motor had to be washed for a long time from the sticky swamp crap. Next, preparations for removing the engine from the frame. I remove the seat and tank...

After putting the chains in place, I replaced the old clutch disks with new ones....