Maintenance on Tony

Www.facebook.com/groups/bmwf650...

The allen bit I was using broke off in the bolt on the primary cover. Any advice for getting this out?...

I've got big plans for a road trip to Oregon next month so I've been spending some time with the Big Red Bitch getting caught up on maintenance. New air filter, new front brakes, also changed the fina...

Prepped the recently acquired ST4s abs for dropoff on Tuesday to get an overdue major service and as well as transfer over some parts from my prior ST4s with the bad motor.   I always remove the...

Always very important, but so very expensive. What do you guys do? Pay top dollar at the dealer, or do it yourself?...

After seeing a few posts on FB about people changing out dirty strainer filters on there bikes I decided to check and replace my own, was a bit of a shock to see just how much crap it had in it from t...

Anybody in or near Philly good with carbs??? seems that I'm getting a pretty good fuel leak. I'm pretty sure it's the petcock because it only happens when I turn it to off and dont bother her for a fe...

Https://www.asphaltandrubber.com/products/bmw-m-endurance-chain/...

Sprockets & chain, last thing to be done before Moto camp season!...

Finishing up from the KLR 650 clutch upgrades, Counterbalancer adjustment lever (doohickey) upgrades, and the #westmanmod oil system upgrades.. So down to air filter, high beam wiring repair, and driv...

-New front tire, installed center stand, changed swing arm oil(it was gross and probably had never been changed), replaced swing arm boot- then rode to Daytona to get a software update.(Idle is MUCH s...

That's another part of my Royal enfield interceptor 650cc I've got to know. Front sprocket cover removed, cleaned out, polished and replaced. Probably lightened the bike by 2lbs of muck! #interceptor6...

It was time for the rear ohlins to have a service. Not easy to get out with the ABS unit in the way. Requires a strip down of the rear of the bike. What followed was swingarm bearing service and addi...

It was time for the rear ohlins to have a service. Not easy to get out with the ABS unit in the way. Requires a strip down of the rear of the bike. What followed was swingarm bearing service and addi...

Repairing a loose connection on the fan pull cord and changing the rear tire. Regarding the rear tire, I've made significant progress: the previous one lasted 16,700 km, this one only 12,700! I'm imp...