Added 2 led pods to the rear fender.

Follow: @lasermax01...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

  Well, I've ...

I am looking 4 sum-1 that can HELP me put on sum lites on Blu Diamond. The reason I said HELP bcuz I would like 2 learn how 2 do it myself. I watched a YouTube video but that didn't help me @ all. Do...

Hey gang, after bn gone 4 a while, I'm back. Also I finally decided 2 put my litez on. Had them n my saddlebags 4 3 plus yrz. Put them on myself. Not a bad job....

Before and after led frt blinker install what do you think?...

Installed a led kit in time to rain....

Our ride from today, it's a run for a good cause. The start was in Merelbeke, with stops in Oudenaarde, Sint-Lievens-Houtem and Gentbrugge over small country roads, for a total of 140km. All in all a...

Thankful to be able to do this home customization verses paying someone else for your visions....

Heel plates & Shock cover and Wrapped the Rear spoke. Still need to add Ducati Corse Graphics, Fit Dash Screen Protector and Clear Clutch Cover and ready....

After refurbishing the front brake plate and replacing the springs and shoes I was confident that the rears would not pose a problem....

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

Once the bearing is below part of the thread the locking cover was used to force the bearing down into place. On the other side the spacer and speedo drive where fitted back in place....

The sprocket is held on with 8 bolts and was very easy to remove I have ordered new bolts and spring washers from Greystone Enterprises for when the sprocket is ready to be replaced. This Sprocket is...