Hot pink rear foot peg thingies lol

After almost 25 years and 150.000kms the foot pegs are like this. time to do something about it....

We continue working on the Sandy project. For those who don't know yet - it is dedicated to building a unique scrumbler based on Yamaha YBR 125 motorcycle. Many people will say that it is strange, com...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

The forward footrests on my Daytona are fixed, while the rear (passenger) ones fold up to be vertical when not in use. The rear pegs mount to the bracket that supports the mufflers. Since this bike...

After all the cleanup and painting, installed on the bike, they didn't look right. Both front footrests were angled up at five degrees or so, surely the result of a number of minor spills I took over...

#bikemeet #ride...

After refurbishing the front brake plate and replacing the springs and shoes I was confident that the rears would not pose a problem....

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

Once the bearing is below part of the thread the locking cover was used to force the bearing down into place. On the other side the spacer and speedo drive where fitted back in place....

The sprocket is held on with 8 bolts and was very easy to remove I have ordered new bolts and spring washers from Greystone Enterprises for when the sprocket is ready to be replaced. This Sprocket is...

During a ‘street only’ shakedown run of the freshly installed (used) rear tire, two dualsport bikes pull out of a random driveway, so I followed them for a while to see if they might be heading to som...