That is a sexy rear , show me yours ?

After refurbishing the front brake plate and replacing the springs and shoes I was confident that the rears would not pose a problem....

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

Once the bearing is below part of the thread the locking cover was used to force the bearing down into place. On the other side the spacer and speedo drive where fitted back in place....

The sprocket is held on with 8 bolts and was very easy to remove I have ordered new bolts and spring washers from Greystone Enterprises for when the sprocket is ready to be replaced. This Sprocket is...

Perhaps the M1000R will also recieve the same change....

A wonderful place that I know even without clouds and bad weather....

During a ‘street only’ shakedown run of the freshly installed (used) rear tire, two dualsport bikes pull out of a random driveway, so I followed them for a while to see if they might be heading to som...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

I would have liked to stop more often to take more pictures. I simply invite you to go there for yourself to get your own idea. Have a good evening friends ❤️...

Whilst spinning the cam plate through the gears I noticed one or two issues. 1. There is a track worn into the cam plate by the cam plate follower and 2. At some points - namely 2nd and 3rd gear the...