More Friday high tech wheel and front brake. Outside the box thinking here...

Bit more of the annual service completed. Front and rear brakes stripped and cleaned.Front and rear brakes stripped and cleaned....

Changed plug and turned a/f screw in 1/8 turn. How many miles before I can pull the plug and see if it helps?...

The RH front bearing locking cover has a left handed screw so you need to turn it in the opposite direction to normal to get it off. I don't have the special tool required and didn't fancy spending £3...

Both are huge differences but considering the Ktm was in way worse condition I would say it has turned out just as good so far. My 93’ cr was complete whereas the ktm was missing many parts and has ma...

And we keep going on and on... As you remember, it was decided to introduce a more powerful fork - from Suzuki GN 125, and also at the same time to install roller bearings in the steering column. But...

Hello! I think I've worked this one out but if my life and all it's ups and downs has taught me anything it's that assumptions turn into the mother of all **** ups. Your assistance is most welcome at...

Forgot to install the primary chain tensioner before the stator. I didn't like the feel of the tension adjusting nut as it caught the edge of the slot of the tensioner blade every half revolution. I...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

At it's deepest it is 68.3 mm so that's about 31 mm from pad face to rear of calliper. Regards...