The stuff…..all the electronics came from the guys at The Factory Metal Works. Pazon electronic ignition, twin lead 12 volt coil, and Boyer battery eliminator....

Having enjoyed a latte and toasted teacake, I say goodbye to #cafeonthegreen and #widdecombeinthemoor and climb the long hill out of the village. A relaxing ride across Dartmoor awaits me until I reac...

It was just a boring run home from work not warp factor 10...

There wuz no TWTT on 05-21-2K24 due to weather. It wuz postponed...

The MCGTTX aftermath continues. The video is a small portion of FM-337. To see more visit my Rumble page - https://rumble.com/c/c-6209327 - There are photographers along FM-337 and one of them got a p...

?...

Removing the front wheel was easy enough. However I later realised you need to loosen the brake plate securing nut before taking the wheel off otherwise the spindle just rotates. Removing the shoes wa...

After removing the cable, the default position is open or closed under spring tension? Anyone know for certain?...

Another year, another MOT pass with no advisories. Simple motorcycle with no complications. Yeah. #Diversion900s #xj900sdiversion #divvymanstravels #diversionxj900s #MOT...

I have started my next, rather secret build project 'Hidden Tiger', named so as the misses doesn't know about it! As I had a spare engine which is the most expensive part of a bike and a lot of other...

What connector connects to the kick stand sensor. I sent mine to a shop and it came back without the sensor. Just need a little guidance on with connector is used for it so I can just bypass it....

Its design reminds me of '90s motorcycles....

Rio Douro, Portugal...

Alright, let's begin. I've finally decided to write my first post. I pondered for a long time about what to write. It seems like everything has already been covered here, but after reading news report...

This past weekend in a little sentence: skies were clear, roads were travelled, fun was had and a cow was photographed?...

Recently started noticing in 2nd gear and 3rd gear at higher rpms get vibrations through my foot pegs and seat. I'm not sure If this has always been there or not, just had a new rear tire put on at a...

Cleaned and Painted...

I just pulled it easily from inside on the left side near the clutch slave. The end was pointed to the ground and not attached...

The bottom half of the motor is mounted into the bike. This will help when trying to assemble the top half because it means I don't have go continually chase around the bottom half. It is rigidly moun...

After studying forums and talking with other "sufferers," several options emerged: - Ignore it (Not for me) - Buy a factory hose (with thermal insulation included) - DIY...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...