What’s everyone’s preferred rear tire?

Does anyone know how to change a rear tire. I've got a Harley sportster that needs it's rear tire changed but because it doesn't match the front tire no-one will swap them out for me. can anyone help ...

Replaced rear tire, spare set standing by. Paid week off= much needed wind therapy ??...

After refurbishing the front brake plate and replacing the springs and shoes I was confident that the rears would not pose a problem....

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

Once the bearing is below part of the thread the locking cover was used to force the bearing down into place. On the other side the spacer and speedo drive where fitted back in place....

Putting new shoes on today....

The sprocket is held on with 8 bolts and was very easy to remove I have ordered new bolts and spring washers from Greystone Enterprises for when the sprocket is ready to be replaced. This Sprocket is...

This bike was supplied new with Dunlop K70 series tires. I'd replaced them many years ago with K81 tires, and though they didn't have many miles on them, and they had plenty of tread left, they were...

Have the new rear tire, sprocket, wheel bearings, brake rotor, and bleed and flushed the rear brake system today. May get the front suspension done today too. It’s mighty cold in the garage today! The...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

  First put on the rim strips, aligning the hole with the valve stem hole in the rim.  On the back wheel, it's necessary to cut holes for the rim locks....