Rode on the original Bridgestone front tire longer than I should have

Do...

They're 5-year-old Q3+'s and the wear bars are worn, but would it still be fine as long as don't ride in the rain?...

This bike was supplied new with Dunlop K70 series tires. I'd replaced them many years ago with K81 tires, and though they didn't have many miles on them, and they had plenty of tread left, they were...

Front wheel is done. New bearings, Avon 65, and rotors.Goes just as fast as you can push her!...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

After some trial rides earlier in the week, I started out for CA from my sister's house in Indy. Stopped for lunch at the Route 67 diner while en route to US 50, which I plan to follow all the way to...

Got the fromt turn signals done. The turn signal assemblies on this bike are Japanese units. They aren't the same as what is shown in my parts manual, and I believe I must have installed them for so...

  First put on the rim strips, aligning the hole with the valve stem hole in the rim.  On the back wheel, it's necessary to cut holes for the rim locks....

  Had some time in the last few days to install the front fender.  I'd previously had the stays rechromed since they had rust spots showing through.  Also replated the stay bracket hard...