Finished the build crash bars, skid plate, hand guards, low seat, wind deflectors..

You can order on my website. It is a pity that the translation of the text did not work out smoothly (roll bars???) https://mexaldshop.com/en/roll-bars-for-honda-rebel-500...

Now this was so much fun to ride.......

Attention to details...

There is much diversity and sceneries to ride through, from the mountains to the sea and islands....

I decided to tackle the seat this week. The original seat was really tired and beat up. All those miles under my backside, much of it with a passenger, had taken its toll. There was an ancient tear...

This project is essentially done. In spite of a few setbacks this weekend, I got the Daytona started today. First, when I went to set the valve clearance, I realized that one of my pushrods had slip...

First adjustment of the rear part with the number plate holder...

I took the stock seat cover off, cut the foam, cut the seat pan......

DIY Bates Desert Racer Seat...

  I never thought the GB500 looked just quite right from the front... All the right elements were there but they just didn't seem to come together properly. The headlight is maybe a bit too big a...

The T100 needs a skid plate……….something like Bast Brothers Welding used to make for the west coast desert racers. I found the photo above at Show & Go Cycle Shop blogspot. I wish I could call up...

The seatcovers on these seats are stretched around the foam and then over the lip on the pan. While it's been done this way for decades without serious problems, that lip seemed awfully sharp to me,...

Tall seat height is perhaps the most common complaint that new riders have with their dual sport bikes. Some riders move on as their skills progress, and they’re fine with taller seats. Other rider...