How to make your own gaskets from copper

The process of building in the pics:...

The bike was in a terrible condition, it took a lot of work for its reconstruction...

After receiving so many enquiries about the building of these bikes i have finally got round to going through step by step on the whole process....

The fuel tank on both bikes came from an early (1980's?????) Honda CG125 Which will require a small amount of work underneath on the tap side in order for the tank to sit down enough to get it level w...

THE WHEELS Rear wheel is standard 17" rebuilt spokes or just powder coat the whole thing as i did on version one choice is yours. Front wheel is now a 19" this is achieved either by using the origina...

BRAKES Again all standard and original except for the Goodridge stainless braided lines for better looks and performance....

Engine Up to you this one but if you bought a good bike to begin with then all you need do is paint it! PJ1 satin engine paint was used and if you follow the directions to the letter you should be f...

The majority of the dominators electrical components CDI, fuse box etc are housed in the now departed fairing. In order to keep the wiring at the headlight to a minimum i simply pulled everything back...

Cut this off using your angle grinder. Make sure to not damage the bearings. After it is cut off grind it so it is smooth....

Remove the cap to expose the bleed valve (3). Connect a clutch circuit bleeding tool to the clutch slave cylinder bleed valve (3). Remove the cover (1) with the membrane from the clutch fluid reservo...

I went to south to rhode island lately. It’s always fun to be near by the ocean....

My answer: "Easy. All you need is a large bag."...

Is there a right/wrong way of sitting on this bike and what would it be? How do you sit? Red is as far to the front as possible, blue is somewhere in the middle and green is to the back of the seat as...

I know mirrored visors are high maintenance and are far less durable then their tinted counterparts but I've had my visor for only about a month and it's already getting scratches and not small little...

I've always been attracted to motorcycles that were fast and high-tech and futuristic. This little beauty defies all of those categories. It isn't a sense of nostalgia... I was 8 years old when the GB...

Let’s face the fact that not everyone will be able to cough up close to $28,500 for their very own 2020 Honda CBR1000RR-R Fireblade SP here in Malaysia. But that doesn’t mean that you can’t have a...