Platinum Cables Installed

Custom cables from Barnett!...

  New cylinder and piston bolted in with a generous amount of oil used to assemble....

Buying all new control cables (not speedo and tach) for the bike would apparently run around $200. Having promised Bonnie I would try to keep costs under control, I looked into building the cables my...

These are the little brass fittings that the soldered wire end slips into so that it can attach to the throttle twist grip. The one on the right was damaged, the left one was made from a piece of 1/4...

The front brake cable was definitely not original. It appeared to be some kind of universal replacement because there was no yoke fitting at the brake end--only a clamp arrangement that allowed adjus...

Taking it for a testride tomorrow...

Used my little tool kit I got for Christmas hahaha...

Just drilled out one side of the base mount to fit and swapped the silver hex bolts with the black torx. Bolts are Tight enough to move the bike with the mount...

Installed on top of the transfer case...

If anyone is curious about what the install is like, check video....

That includes idiot time looking for a bolt that bounced off my runners and shot across the garage....