This is my Tiger Trail 750

Pueblo reservoir...

Removing the front wheel was easy enough. However I later realised you need to loosen the brake plate securing nut before taking the wheel off otherwise the spindle just rotates. Removing the shoes wa...

My bike has an 18inch, WM2 rear rim, it has a 4.1 tyre that states it fits in place of a 3.5, this is good for the purpose I intend to use the bike for, which is riding on sand and dirt, but it does c...

  Managed to get the sludge trap open after liberal application of heat and using a hand held impact driver. Slight delay until I realised that I was actually driving it deeper at one point!...

You’re warming up your motorcycle, adjusting your gloves and doing a last minute mental check of the roads you’ll be taking. Then out of the corner of your eye you see your dog staring at you through...

Freshly painted. Here is the only place you’ll see the spray foam inside....

I only have a frame and some forks from 1978 to start me off so it's not really a rebuild or a restoration. I have no history with the bike, just a burning desire to get this pile of nuts and bolts ba...

OK - here's what I'm trying to emulate - quite rare and I don't even know if these were exported to the US, but in 1980 a small run of these bikes were produced. They have a pig ugly exhaust, 21 inch...