Well that's the engine painted, so next job is putting it back together

Radiator fixed and back in place, starter solenoid replaced, new hugger, new polished alloy dust shields....

Scotland here we come!...

Polished her up, nearly ready to get her registered....

But I'll let you in on a little secret... I had PSI down to 12!!! Note... no need to fact check this, the photos proves it!!! ...

Had to spray it black as i don't have green... fixed the rear caliper so now we can go out again tomorrow ...

No bubbles and perfectly in line. Also added the carbon look lower sticker... BTW black is a pain to keep and get clean. I going to try and save the old sticker. Going to use a hot soaked rag, get it...

10 inch apes fitted with heated grips which needed fed back through, bit of a challenge but got there...

We are still missing 2 parts to fit the flatside CR carbs... I ordered it and I will get them in August... I'll have to wait for a long time unfortunately! I will fit a normal ZXR carb wainting for my...

Finally after quite a few months I got her all back together! Took so darn long with parts being on backordered. But it’s all good now?...

Had the bike down for a week waiting on new parts. Installed new rear sets, chain and sprockets, new integrated tail light and battery, re-greased wheel bearings and axle and fixed wiring problems. ho...

Got the wheel back in, and it looks aces...

Didnt like how it was looking, so i cut it off!...

Dont forget to like and subscribe...

Swing arm has been cerakoted new bearings etc.... and I had the cam cover polished thanks to the "The zed shed" I couldn't polish it myself but managed to polish everything else that needs polishing....

While the overall design looks similar to the current LC8c twin, there is a new casting for the block, cylinders and head.It’s essential to take note that the LC8c mill is unique, mainly bec...