The crank was tight in the bearings. I tried everything to loosen her up but in the end had to split the crank cases and review the situation. I decided that the TS bearing was causing the problem (i...

Gary Michaels...

This project is essentially done. In spite of a few setbacks this weekend, I got the Daytona started today. First, when I went to set the valve clearance, I realized that one of my pushrods had slip...

Polished her up, nearly ready to get her registered....

I bet it I know it was the guy speeding past me about 10 min earlier in the 4x4 as had not passed anyone else for well over 30 min. I know a lot of pathetic 'men' who would run an animal over just bec...

I recently changed the oil, belts, shorai battery and plugs. airfilter looked fine...

Kimego Peat Works. County Kerry. Ireland...