My rear brake pads - whoooops ?

FAQ • Contacts • Privacy policy • Agreement • Rules of Conduct

ST.LL

My rear brake pads - whoooops ?

I'll get a few more miles out of these surely ??

12

5

Follow 2.5K

Comments

Aussierider 06 Mar 2021
Translate

Got your money worth out of those bad boys!

0
Reply
- ST.LL 06 Mar 2021 author
  Translate
  
  Aussierider, Inadvertently! indeed I did. Shame on me really for not checking them before.
  
  1
  Reply
Matt Carroll 06 Mar 2021
Translate

how's your disc looking?

0
Reply
- ST.LL 06 Mar 2021 author
  Translate
  
  Matt Carroll, It's actually unscathed thankfully. I took the wheel off to clean the chain properly and change my brake fluid. luckily I usually have spares of everything (including tyres), so when I checked the pads I swapped them striaght out ?
  
  1
  Reply
TwoNine 06 Mar 2021
Translate

That’s what you call using every last Penny.

0
Reply

Please Log In or install the app. Comments can be posted only by registered users.

Related

Dominik Obrstar

Dominik Obrstar

Brake pads change?✌

Brake pads change?✌

11

2

Jack Smith

Brake pipe chafing

If you have the OEM fog lights and you have fitted a lowering link(dropping front forks by 15mm) this could cause chafing on the left hand brake pipe it’s happened to me. My dealer has refered the iss...

Brake pipe chafing

6

0

Dark Mind

Rear Brakes - Tiger Cub T20CA

After refurbishing the front brake plate and replacing the springs and shoes I was confident that the rears would not pose a problem....

Rear Brakes - Tiger Cub T20CA

5

0

Dark Mind

Rear Wheel, Tyre, Inner Tube & Rim Lock

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Rear Wheel, Tyre, Inner Tube & Rim Lock

4

0

Dark Mind

Rear Whell Bearings & Speedo Drive

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

Rear Whell Bearings & Speedo Drive

3

0

Dark Mind

Rear Wheel, Tyre, Inner Tube & Rim Lock

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Rear Wheel, Tyre, Inner Tube & Rim Lock

3

0

Dark Mind

Rear Whell Bearings & Speedo Drive

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

Rear Whell Bearings & Speedo Drive

5

0

Dark Mind

Rear Whell Bearings & Speedo Drive

Once the bearing is below part of the thread the locking cover was used to force the bearing down into place. On the other side the spacer and speedo drive where fitted back in place....

Rear Whell Bearings & Speedo Drive

3

0

Richard Angelino

Richard Angelino

In my opinion, the rear brake isn't necessary

I never use my rear brake unless specifically to keep it clean. If I'm in an emergency apply my front brake into a near stoppy, making the rear that much more useless. Like what's a good time to use t...

In my opinion, the rear brake isn't necessary

4

3

Dark Mind

REAR WHEEL SPROCKET

The sprocket is held on with 8 bolts and was very easy to remove I have ordered new bolts and spring washers from Greystone Enterprises for when the sprocket is ready to be replaced. This Sprocket is...

REAR WHEEL SPROCKET

1

0

Steve S

Rear tire change day (and more)

During a ‘street only’ shakedown run of the freshly installed (used) rear tire, two dualsport bikes pull out of a random driveway, so I followed them for a while to see if they might be heading to som...

Rear tire change day (and more)

8

2

Danny

Rear hugger fitted, fiddly , but on and solid, cleans it up a bit

Rear hugger fitted, fiddly , but on and solid, cleans it up a bit

6

0

Suzuki GSX 750 Katana - Second katana.

Suzuki GSX 750 Katana - Second katana.

Brakes... brakes.... oh dear...

So.. No I haven't come off but this is about my brakes.....

Brakes... brakes.... oh dear...

7

0

Honda CBR 600RR

Honda CBR 600RR

Brake pads done for?

Hello everyone, quick question: Can these Brake pads still be used? Bike is a Honda CBR 600RR and these are from the back brake calliper. just did new ones in the front (all 4 of them). Do these also...

Brake pads done for?

7

2

Triumph Tiger 750

Triumph Tiger 750

More Help Please - Rear brake caliper mounts this time

Hello! I think I've worked this one out but if my life and all it's ups and downs has taught me anything it's that assumptions turn into the mother of all **** ups. Your assistance is most welcome at...

More Help Please - Rear brake caliper mounts this time

6

0

Triumph Daytona T100R

Triumph Daytona T100R

Part 8 - Rear wheel & brake

Finished the rear wheel and brake.  I had forgotten that my rear wheel is not original.  Some time in the mid 70s I noticed my rear sprocket was worn, so I decided to replace it. ...

Part 8 - Rear wheel & brake

8

0

Kawasaki Ninja ZX-14R

Kawasaki Ninja ZX-14R

Rear wheel weights fell off

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

Rear wheel weights fell off

5

2

Honda GB 500 Clubman

Honda GB 500 Clubman

This is something I've done on almost every motorcycle I've owned: braided stainless brake lines. It's a cheap upgrade that's easy to install, gives a noticeable improvement in braking feel, and looks...

Brake Upgrade

2

0

Menu

Posting

Sign In

See More

FAQ • Contacts • Privacy policy • Agreement • Rules of Conduct