I found this old fuel tank, but could not find anything similar to it online.

Helping clean out my friend's garage and found this old looking Honda gas tank. He never owned a bike, so most likely his dad's since I remember him being pretty into motorcycles but he's not around a...

#4DsLife https://www.instagram.com/danny4ds/?utm_source=qr...

#RidetogetherFamilyForever #LoyaltyisEverything #RideSafebeSafe 2Wheels Vibes ! #4DsLife ?...

So I kind of made my own. I need to lower it slightly to get it under the screen but that should do the trick ?...

Found this Honda in a house just bought. Would like to restore it....

This is a very rare Egli Vincent. Fritz Egli was a Swiss designer. His Vincent frames are the best known of his work and just exquisite. The Vincent engines represent one of the peaks of British motor...

I'm getting ready to paint the tank and fenders. To ramp up to this there is all the standard sheet metal prep work, but before that, I wanted to make sure the tank was in good enough shape to use....

Now it is just rust to deal with. There are a lot of ways to remove rust from steel. One way is acids. Strong ones like muriatic (hydrochloric), or weaker ones like phosphoric, acetic (vinegar), ci...

The only other oriface in the tank is for the fuel petcock. To eliminate as many external sources of leaks as possible, I decided not to use the petcock, but use a simple hose barb adaptor instead....

The leak was where the rear mounting tab was welded to the tank. It looked like an incompete weld, or a weld may have pulled loose or cracked. This would likely be a high stress area, and it's possi...

After I posted the above, I got a couple of messages that I had overlooked one potential source of leaks. The way I plugged the filler neck with an expanding stopper put the filler neck joint outside...