I just got my cylinder back from Harley Davidson of Calgary with the new 101mm sleeve installed and honed. As soon as the cylinder head is finished it will all go back together..... hopefully soon!&n...

Took off work at little early and visited these historic Kansas arch bridges...

Saftey wire to the rescue!...

So I sold my 76 wr250 because I was tired of messing with the bike…...

Any tricks to get it off? I don't have hardly any tools other than the ones that came with the bike to work on it...

Adding the final touches made for a great time. I could finally see my hard work pay off when the bike was completed. Overall I had an absolute amazing time building it and I will never forget the exp...

??...

Honda engines have some weaknesses, one of which is the timing chain tensioner. While this issue is not as critical for inline engines, it is more problematic for V-twins. The engine couldn't be turn...

Todays fun job. The hose going onto the pump is being stubborn...how fun. Wish me luck!...

Gathered up The NC21/24 one-way clutch arrived....

I've managed to acquire (thanks Steve) a set of cases and outer covers for a T140 as a mock up so I can properly set up the new foot peg, gear change and brake locations. Even though it's hollow and t...

When you're on a beautiful, quiet Devon A road, the only other vehicle is a biker, then the road opens out to a long view of a straight. #divvymanstravels #motorcycling #ridesafebacksafe #ridetosurviv...

What are these black little marks on my exhaust? Is it caused by heat or is it rust. Anyone had experience with something like this, usually polishing it gets em out but is there any solutions to stop...

Two guys completed the road trip from Dumb and Dumber while on a mini bike....

How to unplug the 3 pin plug connecting the regulator to the alternator on a Royal Enfield Interceptor 650. The manual gives no instructions on this and it is very inaccessible beneath the engine and...

From Whitehaven down the West Coast Road, up past Windermere, over Kirkstone Pass, on up past Ulswater then the A66 & A595 home....

First step was to build the dust excluder assenblies. This is really just installing seals and O rings. Apparently some time during '71, there were two seal designs. One was a conventional pressed-...