Cleaning Engine internals

[b]Engine mods:[/b] The stock Phillips head engine screws were replaced with a stainless steel Allen head bolt kit. All 8 valve tappet cover seals were replaced New clutch housing gasket was installe...

Unfortunately the previous owner gave this bike a hard life and the engine needs a full rebuild as when I opened it up, there was a lot of bolts rounded, clutch nut damaged, bolt missing off of oil pu...

It took me about 45 minutes to remove all the engine mounts and then to pull the engine out of the frame, but it takes you less than 2 minutes to see how I did it. Bike is a 1974 Honda CL200 (same eng...

Found this gem on eBay… never seen one before so thought I’d take a punt… I don’t know if I like chrome through… ...

The mineral oil keeps the clutch plates lubricated best in my 1600 Kawasaki. Bel-Ray Hypoid gear oil is for the shaft drive this particular bike has. I currently live and ride daily in Las Vegas where...

I did just manage to change the oil ACCORDING to manual. Started up checked oil level. Added more. Started and checked. All in normal levels. Normal kawi tick? Note that this ticking and smoke on star...

Cleaning my rims tonight. I had to put my new spools on to lift the back too....

ZX1100-D1 Engine was a runner, open to offers ,collection only KENT ME8...

1979 CB750 restore...

Early start to clean the bikes and do some maintenance....

The thrill of those engines roaring to life....

The engineering students from the University of Michigan have been experimenting with their electric bike build since 2013....