I just looked at the pictures and the condition of the hulls is not as bad as it looks on the screen, honestly. There's another weld on the underside of the cases, which won't be visible on final asse...

The GB601 is finished.... for now. I gave it a wash and wax and detail and spent a bit of time riding it. It's a lot of fun and makes a great sound. It will definitely draw a crowd on bike nights. Can...

Ready to take this puppy home. ...

I had planned to be at work, but this was worth it. (I did show up to my job eventually)....

While successfully dodging several clusters of thunderstorms. Rode through a few wet areas, but always just after a storm had blown through. Crossed over three summits of about 8,000 feet along the wa...

I hv 2 do sum serious maintenance on Road Runner (my bike) this wk...

Featuring artist C'ing Jerome...

2017.02...

I previously visited about 5 years ago but as I heard its closing at the end of August I wanted to go again. Its well worth a visit before it closes. #Moretonhampsteadmotormuseum #carmuseum #motormuse...

I did about 1500 kilometres (~300km per day). Pictures shown are from Maltatal dam, Großglockner, Stelvio pass, Val Gardena and Cortina D'Ampezzo. Hope you like it....

Source:...

The Pierer Mobility Group bikes this season have had a little bit of a tough go at it in recent rounds and it does seem that since the start of the season they haven't been able to keep up with the pa...

So off out to Honister Pass to road test them. Perfect...

I’ve seen these guide/guards built around the rear cheater sprockets on a few old sleds. I know that back in the days these bikes were raced chain quality was pretty poor, and riders routinely carried...

I have read that removing the swinging arm spindle is the single most difficult task to do on a Tiger Cub. So far I have sprayed it with WD40 and given it a tap with a hammer and drift, with no moveme...