Get to do my first rear wheel removal today

Well we did it. The first races are done....

2 weeks ago minus degrees and snow, now 17°C and blue sky....

After 3.5 months of medical appointments, hydrotherapy and physio, the moon boot and a long came off and I was itching to get back on a bike.... The crash definitely got into my head but I didn't want...

#irffir #mbbm #ironrocketsmc...

I was going in the opposite direction of the way the bike is facing. A car was coming around the corner sliding and I had to chose the ditch or the car....

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

The sprocket is held on with 8 bolts and was very easy to remove I have ordered new bolts and spring washers from Greystone Enterprises for when the sprocket is ready to be replaced. This Sprocket is...

I drove 350 kilometers through the small villages. I was traveling alone. Just the right thing....

Have the new rear tire, sprocket, wheel bearings, brake rotor, and bleed and flushed the rear brake system today. May get the front suspension done today too. It’s mighty cold in the garage today! The...

As I said, intro, I did not keep the original spoke wheels but put the Z400 model spoked wheels. The rear wheel that I bought secondhand really was tarnished and pitted by rust....

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

With a coffee in Barbizon, a stop at Jc Chouby, a stop at Milly la Forêt and the Farcheville castle then back to Paris. Despite the light rain, the beautiful colors of autumn make us appreciate this q...

#1...

#2...

Triumph Motorcycles presents the finished TE-1 prototype. After years of development and numerous test runs, the project is now complete. But there will be no production model....