TKC70 front + Heidenau K60 Scout rear

Bit more of the annual service completed. Front and rear brakes stripped and cleaned.Front and rear brakes stripped and cleaned....

These stands with wheels are worth their weight in gold... Fantastic! $225.00 on Amazon......

I broke the bolt because i tried to tighten it without proper tools?. Can i ride with this? Also does anyone have tips on how to remove it without damaging the rest of the spindle?...

The RH front bearing locking cover has a left handed screw so you need to turn it in the opposite direction to normal to get it off. I don't have the special tool required and didn't fancy spending £3...

After refurbishing the front brake plate and replacing the springs and shoes I was confident that the rears would not pose a problem....

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

The rear wheel rim is a WM2 and it was not holding air so I knew I would have to replace the inner tube, also the rim lock bolt looked to be in terrible condition....

Once the bearing security cover has been removed the spindle can be tapped out using a hammer and drift, this also removes the bearing on the other side. The speedo drive can them be gently tapped off...

Once the bearing is below part of the thread the locking cover was used to force the bearing down into place. On the other side the spacer and speedo drive where fitted back in place....

The sprocket is held on with 8 bolts and was very easy to remove I have ordered new bolts and spring washers from Greystone Enterprises for when the sprocket is ready to be replaced. This Sprocket is...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

Got the fromt turn signals done. The turn signal assemblies on this bike are Japanese units. They aren't the same as what is shown in my parts manual, and I believe I must have installed them for so...

  Had some time in the last few days to install the front fender.  I'd previously had the stays rechromed since they had rust spots showing through.  Also replated the stay bracket hard...