I came across this on the internet a few months back. I am in the middle of chopping a spare set of cans for my ST4. I have used this as the basis of my mod. I will try to add an extra section to this...

Lower left half was broken in two pieces, top fairing a piece was barely holding on and another big chunk missing. Read online that abs plastic can be melted with a soldering iron so i grave it a try...

While waiting to treat the tank, I changed the fuel filter and inside the old one I found rust sludge .......

Evening everyone! Just wanted to share something I just found out about the drivetrain. The chain sliders had uneven wear so I changed them and also bought new chain rings and chain... Some kms have...

Guess who dropped their special ultra light weight pressed metal brake leaver pivot nut down inside the fairing today I shall see what Mr Bembo wants for a replacement, and the nut may still be ther...

You need 12 off 17mm x 6mm Dzus fasteners and 12 slip on clips. D8 are the better machined fasteners. Available in crosshead , allen hex or D tab for hand removal. 3 along the top of the mi...

Shank Diameter Also called Major diameter. The diameter of a bolt is the Shank diameter, expressed in millimetres for Metric bolts. Because this is approximately the same as the Major or Thread diame...

Summary: My charging system diagnosis procedure, modified over time to generally point out the problem through a series of steps. I try to follow it every time, as that way I don’t miss anything...

A leaking oil seal and wanting to uprate fork springs were my reasons for attempting this, the basic oil change is covered well in other docs. OK, prep work first....  Record all your fork...

After the last post I decided that it was worth ordering and fitting a new set of brushes to the starter on the ST2. At less than £10 a set and only an hours job to change them, it made no sense not t...

Remove the tank from the bike Now is a great time to inspect the fuel lines that are attached to the bike....

You need 12 off 17mm x 6mm Dzus fasteners and 12 slip on clips. D8 are the better machined fasteners. Available in crosshead , allen hex or D tab for hand removal. 3 along the top of the mi...

Although this isn't strictly a riding technique there's a lot of false information about the 'correct' set up for a bike's suspension. The one main thing that most of these articles miss is the most c...