? arrow exhaust??

So I think I've reached my limit with ROSI3'S Exhaust!!! This 1 that I just put on will b the 6th one on this bike in 1 year!!! SMFH!!! Stock (1), everyone gets rid of the stock one, YOSHI r5 (2) that...

She’s installed as well as block off plates and PCV....

Hi, I am looking for a new or used True Dual performance exhaust system (headers & muffler or straight pipe) for my 2019 Road Glide Special. The system must be black in color or either; come with blac...

Try some autosol metal polish and wipe it off/light buffing. Then go over with wd-40....

What are these black little marks on my exhaust? Is it caused by heat or is it rust. Anyone had experience with something like this, usually polishing it gets em out but is there any solutions to stop...

Craziest customization I've seen in a while ?...

This should have been one of the easy jobs, but I couldn't even get the exhaust silencer off, not a great start to the mechanical work on the bike. I tried WD40 and a nylon mallet with no success. I e...

Exhaust stripped back, resprayed and looking as new. Test it out next weekend....

Without going down the remove route does anyone know a way to unseize the exhaust valve. I have taken the nut, disc and spring off and cannot turn it even with 6mm that fits the flat. Releasing the ca...

I don't think anyone has brought up this question, BUT...Reason I'm asking: I have GSXR and am going to modify the exhaust to basically a full racing system. I'm going to take out the SET valve butter...

Lat night I switched the 2-up footrests back to the standard solo rearsets. Very simple switch on the left side, a bit trickier on the right side. The left rearset just bolts on, but the right needs t...

Beautiful ceramic coating (The Factory calls it “cool chrome”)...

After removing the cable, the default position is open or closed under spring tension? Anyone know for certain?...

The exhaust thing can be done as these photo's demonstrate. I guess if you have the skill, time, materials, money and vision most things are possible. I just have to be realistic about how much of tha...

The exhaust adapters…………Tri-Angle Metal Fab made the rough blanks, I bored them, notched them, and took some material off of the outer surface. They press into the heads and the Factory Metal Works pi...

So I've been saving up my money for the exhuast system for the Daytona. The 30-odd year old Dunstall mufflers on the bike, while not rusted through, were pretty much just chrome containers full of ru...