CBR 900 Blade project

Hi all, I start my first project ever and probably the last, who knows. It's start before few months when i look for CBR 900 '96 year and no luck until one day i get offer for '98 cbr fireblade that i couldnt let it go. So I start dissasmbly it until last bolt on it (I have about over 300 pictures taken) and i will put only few pictures for now where I'm now with it.
When i buy it

And it start, a lot of cleaning (probably not cleaned from year when it come out from factory) changing every bearing that was not good, still waiting for gaskets

And then a lot of calls, pm messages on forums, mails, etc. until i get the vfr swing arm that i needed, and then again every bolt picture, lot of cleaning, complete front fork repair (will have them until i get another USD forks with radial calipers, still looking for them) and this is where I end now

Tail is finished started working on fairings below seat and the seat as i couldnt find original so decide on this move, and i started the motor after few months when i start on project what i was little scared that it will not

Seat mold:

Wheel so it now time to order the tyre metzeler m7rr 200 55 17, put new levers and waiting for new oil reservoir. Image of wheel hope you like it, i didnt have many choices, few models only with this bolt pattern and et

last two weeks didnt do anything on it, a lot of other things to do so didnt have much time, today I succesfully mount tyre on car rim with a lot of troubles and very close to give up and sell tyre and rim, but it's mounted and this is the last big detail that i need to finish.Here is the image of mounted rim

After long time what i didnt do anything because of my job, i decide to finish project and what i saw when i remove cover from bike that paint start fall off from frame, after first shock i decide to start again, first of all i dissasmble the whole bike and then start to search for company that can remove all paint with sand blast, now is all parts at painting and waiting for them to start from zero again, images at bottom will show what happend

After sand blast

What i done is that i build complete electric from zero, using waterproof jacks, break ohlins shock and luckily i found spare part and could fix it, OEM licence plate from rsv4 with oem led turn signals, new ignition, gas cap, remove handlebar and put zx10r clip on bars, complete front from zx6r, new bracket for headlight, ignition is on right side near machine, ordered rizoma mirrors, decide to use aprilia shiver akrapovic's not yoshimura race pipe, still to do is make bracket for rsv4 side stand, waiting for front fender to finish, and seat mould is new and now need to found who will finish it with lather, so here is few images, but at least i can say that i'm almost finished for second time