Front Brake lines

So.. No I haven't come off but this is about my brakes.....

2 rotors, 8 pads so easy a caveman could do it....

Hello everyone, quick question: Can these Brake pads still be used? Bike is a Honda CBR 600RR and these are from the back brake calliper. just did new ones in the front (all 4 of them). Do these also...

Upon inspection I found that both bolts holding the left caliper were gone and the caliper was just hanging there. I think I may have ridden that way for 100 miles. As it was I was 80 miles to the cl...

Forgot to install the primary chain tensioner before the stator. I didn't like the feel of the tension adjusting nut as it caught the edge of the slot of the tensioner blade every half revolution. I...

I'm changing out my chain and sprockets to a 520 conversion but I'm not sure which way the front sprocket faces. How can I measure which way it faces with one side having a shoulder and not the other?...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

This is something I've done on almost every motorcycle I've owned: braided stainless brake lines. It's a cheap upgrade that's easy to install, gives a noticeable improvement in braking feel, and looks...

Got the fromt turn signals done. The turn signal assemblies on this bike are Japanese units. They aren't the same as what is shown in my parts manual, and I believe I must have installed them for so...

  Had some time in the last few days to install the front fender.  I'd previously had the stays rechromed since they had rust spots showing through.  Also replated the stay bracket hard...

Bit more of the annual service completed. Front and rear brakes stripped and cleaned.Front and rear brakes stripped and cleaned....

If you have the OEM fog lights and you have fitted a lowering link(dropping front forks by 15mm) this could cause chafing on the left hand brake pipe it’s happened to me. My dealer has refered the iss...

Removing the front wheel was easy enough. However I later realised you need to loosen the brake plate securing nut before taking the wheel off otherwise the spindle just rotates. Removing the shoes wa...

I broke the bolt because i tried to tighten it without proper tools?. Can i ride with this? Also does anyone have tips on how to remove it without damaging the rest of the spindle?...

The RH front bearing locking cover has a left handed screw so you need to turn it in the opposite direction to normal to get it off. I don't have the special tool required and didn't fancy spending £3...