Carbon 2 race mudguard to finish off the front :)

Most the welding and shaping done now...

I'm changing out my chain and sprockets to a 520 conversion but I'm not sure which way the front sprocket faces. How can I measure which way it faces with one side having a shoulder and not the other?...

The day was cold, windy, also some rain and fog… perfect day to take my Pan America...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

Got the fromt turn signals done. The turn signal assemblies on this bike are Japanese units. They aren't the same as what is shown in my parts manual, and I believe I must have installed them for so...

  Had some time in the last few days to install the front fender.  I'd previously had the stays rechromed since they had rust spots showing through.  Also replated the stay bracket hard...

Sadly been off my bike since Tuesday. had event where I needed to ride myself to the Doctors that ended up getting an Ambulance to take me to the hospital. I'm all good, just a new changes to life. B...

I'm sure most of you will have seen this already but Troy Herfoss Racing is off to moto America to race in the baggers...

Heel plates & Shock cover and Wrapped the Rear spoke. Still need to add Ducati Corse Graphics, Fit Dash Screen Protector and Clear Clutch Cover and ready....

I broke the bolt because i tried to tighten it without proper tools?. Can i ride with this? Also does anyone have tips on how to remove it without damaging the rest of the spindle?...

The RH front bearing locking cover has a left handed screw so you need to turn it in the opposite direction to normal to get it off. I don't have the special tool required and didn't fancy spending £3...

Source : Pipe Burn...

There is much diversity and sceneries to ride through, from the mountains to the sea and islands....