I was ready to mount the forks on the frame, and, in an uncharacteristic flash of foresight, I realized that assembling the entire bike up on the work table may not be the smartest plan.  Do...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

Pretty much ready to install...

Time to dip the twin Amal 626’s and get out who knows how many years of gunk, varnish , and other deposits residing in the carb bodies. I like this Gunk brand cleaner……….the gallon comes with the part...

There is not much mechanically mysterious in the Triumph rocker boxes, but they do have a few wrinkles, and are subject to leaking in a couple of places. One potential leaking location is the gasket s...

Here are the two chain adjusters. The one on the left looked like the one on the right about an hour before. I took the opportunity to clean up the profile of the part prior to plating--squaring up...

On previous restoration projects (cars and other things--this is my first bike), I've always struggled with what to do about the hardware. In most cases, the hardware was zinc or cad plated originall...

There are bound to be issues with it - the main one is that it only has a four speed gearbox which is non standard. Not sure if I want to try this out or flog it and buy a five speed...these are going...

Flat surfaces seal better, so I wanted to make sure that not only the head gasket surface, but also the rocker box seating surfaces were flat. I used a process the Brits call "linishing", and we Amer...

Head was basically intact, but dirty, and some rust on the ferrous parts. Chambers were carboned up. Seats were a bit recessed, but no signs of cracks....

Headlight has arrived. It's a big old unit!...

Frame and forks delivered at Stotford engineering for the necessary fettling to be carried out. They are going to use the standard T140 head bearings and adapt them to fit the KTM forks, then modify...

The exhaust thing can be done as these photo's demonstrate. I guess if you have the skill, time, materials, money and vision most things are possible. I just have to be realistic about how much of tha...

I was ready to mount the forks on the frame, and, in an uncharacteristic flash of foresight, I realized that assembling the entire bike up on the work table may not be the smartest plan.  Do...

I've managed to acquire (thanks Steve) a set of cases and outer covers for a T140 as a mock up so I can properly set up the new foot peg, gear change and brake locations. Even though it's hollow and t...

I've been working slowly on the forks for the past few weeks. A lot of distractions lately, but things are still moving. From an appearance point of view, I knew I'd be repainting parts, but the cur...

I put the foot pegs and the rest of the motor into the bike. The piston rings were too big for the cylinder but that was easily fixed with some filing. The copper gasket that goes between the top of t...

I sandblasted the frame and ther parts a few weeks ago, and can finally start putting some of them together.  Once set up, sandblasting is a quick way to get down to bare metal, especially in har...

Lmk what you think, I heard random intermittent clunking noises at idling wondering if this is the reason? Bike was dropped on the right side....

The stuff…..all the electronics came from the guys at The Factory Metal Works. Pazon electronic ignition, twin lead 12 volt coil, and Boyer battery eliminator....