3XM front fender

2 rotors, 8 pads so easy a caveman could do it....

Galfor Steel Braided...

Going to start at the front and work our way back. Up first, fork service and revalve, new brakes, rebuild the caliper, new Tusk DSport front tire, repack front bearings, new fork boots....

Icelandic text But…. ?...

I'm changing out my chain and sprockets to a 520 conversion but I'm not sure which way the front sprocket faces. How can I measure which way it faces with one side having a shoulder and not the other?...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

Got the fromt turn signals done. The turn signal assemblies on this bike are Japanese units. They aren't the same as what is shown in my parts manual, and I believe I must have installed them for so...

  Had some time in the last few days to install the front fender.  I'd previously had the stays rechromed since they had rust spots showing through.  Also replated the stay bracket hard...

Finally got my R6 front end in for my FZ-07. Very much can't wait to get these forks on here. It's going to look so much better and should handle nicer too. Pretty pumped....

In need of a front rim for a CBR 1000RR 2004-2006 specifically...

Bit more of the annual service completed. Front and rear brakes stripped and cleaned.Front and rear brakes stripped and cleaned....

These stands with wheels are worth their weight in gold... Fantastic! $225.00 on Amazon......

I broke the bolt because i tried to tighten it without proper tools?. Can i ride with this? Also does anyone have tips on how to remove it without damaging the rest of the spindle?...

The RH front bearing locking cover has a left handed screw so you need to turn it in the opposite direction to normal to get it off. I don't have the special tool required and didn't fancy spending £3...

Its not oem but it is an old acerbis part which is cool ?...