Front brake pad replacement.

OK guys.......time to change the exhaust .....any thoughts?advice what will be better? I will post a list I found for my bike...

21) Galassetti...

So.. No I haven't come off but this is about my brakes.....

So, in lockdown I decided I know, I'll sort and clean the brakes.....

Galfor Steel Braided...

Hello everyone, quick question: Can these Brake pads still be used? Bike is a Honda CBR 600RR and these are from the back brake calliper. just did new ones in the front (all 4 of them). Do these also...

In fact, there are still many different compositions of pads, for track, civilian use, in my small experience - if you do not drive on the track, you need to put on the front civilian baked, and the r...

I'm changing out my chain and sprockets to a 520 conversion but I'm not sure which way the front sprocket faces. How can I measure which way it faces with one side having a shoulder and not the other?...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

This is something I've done on almost every motorcycle I've owned: braided stainless brake lines. It's a cheap upgrade that's easy to install, gives a noticeable improvement in braking feel, and looks...

Got the fromt turn signals done. The turn signal assemblies on this bike are Japanese units. They aren't the same as what is shown in my parts manual, and I believe I must have installed them for so...

  Had some time in the last few days to install the front fender.  I'd previously had the stays rechromed since they had rust spots showing through.  Also replated the stay bracket hard...

Yay I get to change brake pads today. Gota luv bike maintenance...

Bit more of the annual service completed. Front and rear brakes stripped and cleaned.Front and rear brakes stripped and cleaned....

Removing the front wheel was easy enough. However I later realised you need to loosen the brake plate securing nut before taking the wheel off otherwise the spindle just rotates. Removing the shoes wa...

I broke the bolt because i tried to tighten it without proper tools?. Can i ride with this? Also does anyone have tips on how to remove it without damaging the rest of the spindle?...

The RH front bearing locking cover has a left handed screw so you need to turn it in the opposite direction to normal to get it off. I don't have the special tool required and didn't fancy spending £3...