Drive chain following chain adjustment for slack (50-60mm) when on centre stand. Rear wheel axle nut tightened to 95 to 105 ft-lbs. The laser alignment tool I got from Bikesmart for £66.90 inc vat and...

I did the tap test and found this. Checked a video how to fix it. Bam! Simple maintenance done. Maybe some of you may want to tap test your spokes before your next ride.  Safe travels?️...

Not sure if I'll be tarred and feathered or possibly revered, but this is my solution for the loud open air filter. There is a noticeable difference in noise just putting the plate on and off the top...

After putting the chains in place, I replaced the old clutch disks with new ones....

As it should be Enduro, the bike is dirty, the motor had to be washed for a long time from the sticky swamp crap. Next, preparations for removing the engine from the frame. I remove the seat and tank...

Make sure your filter housing is completely seated (fully clipped in) before reinstalling! Spent way too much time trying to figure what was going on ?...

I have been umming and erring on whether I should do this or not. The only KTM dealer who I trust to do this just quoted me between £800-£1000 (about 950-1150 euros) so I have decided to take the matt...

The bigger the bore, the softer the engagement. It should improve the function a lot....

Move the bike slowly so as to find the position where chain upper section is more tensioned. Set the motorcycle on the side stand. Measure chain tension at the centre of the lower section, with the...

Remove the cap to expose the bleed valve (3). Connect a clutch circuit bleeding tool to the clutch slave cylinder bleed valve (3). Remove the cover (1) with the membrane from the clutch fluid reservo...

Clutch fluid is corrosive and will damage paint. Avoid contact with eyes and skin. In case of accidental contact, wash thoroughly with water. Fill the reservoir with specified fluid taken from a...

There are many opinions about the defective tire. I decided to check the wheel runout. I know - it's not very professional to write it, but I gathered some information. Rim +/- 0.2 mm Tire edge +/- 0....

16 45 sprockets fitted, quick test ride and I can't believe the difference it has made. Transformed the bike. Fuel filters next and then a look at the power commander map etc.....

-Front wheel, brake caliper and fork guards off -Loosen top triple clamp bolts and break the caps loose -Remove forks and unscrew the caps the rest of the way -Pull down the fork spring and insert...

I think it's going to be a bit louder than the ridiculously quite standard Akrapovic....

Brake discs (rotors) should all have their minimum thickness stamped on them, the discs will wear over time and once they get down to the minimum thickness then they should be replaced....

So it was chain and sprockets time so I decided to add a tooth to the front sprocket. as I use this bike for pretty much a bit of everything from commuting to playing on the twisties to touring. only...