Hi Everyone! Today i am going to share with you how to take rust out of an old Harley motorcycle flywheel with the electrolytic rust removal principle. All you need is a plastic bucket (non conductiv...

The bearing race was way too loose on the top of the 1980 frame for an unknown reason, and it need to be repair, so my friend ask me to take care of it for him, he heard that I have done something sim...

Let the sanding begin!! Tough work.. a LOT of elbow grease. I also took apart the wheels/hubs so I could shine them up!...

Hey all,...

New wheel bearings front and rear $60...

This is how I painted my old, used motorcycle wheel spokes. The same process should work for bicycle spokes as well. The bike is a 1974 Honda CL200. The spokes are cadmium plated steel (I think)....

The old rims on my 1974 Honda CL200 had seen better days. They were dented, out of true, scratched, a little rusty, and no longer safe. I tried pounding out the dents with a mallet and then with a blo...

Cleaned up and partially restored my gauges....numbers are still a bit sunbaked.......

The day finally came......

Realizing the tank I had was just too far gone for a ratrod look, I started the search for another 78 tank.......

This is where the story started.... A Craigslist ad for a 78 GS1000 that had not been started since 1990....$400...

[b]Engine mods:[/b] The stock Phillips head engine screws were replaced with a stainless steel Allen head bolt kit. All 8 valve tappet cover seals were replaced New clutch housing gasket was installe...