My right side clicker is "crunchy" and not as smooth or precise stops as the other side. It's not the damping rod or anything else below, it's the upper clicker assembly as it does it while the top is...

Always a good feeling! Wish they stayed this pretty....

Make sure your filter housing is completely seated (fully clipped in) before reinstalling! Spent way too much time trying to figure what was going on ?...

I know new tires are naturally slick but when they are inflated to nearly 50 psi they're very slick. Luckily this is the brunt of the damage and I'm fine....

Any screw, nut or bolt that falls in here is never seen again!??...

16 45 sprockets fitted, quick test ride and I can't believe the difference it has made. Transformed the bike. Fuel filters next and then a look at the power commander map etc.....

It seems to be a filter. Don’t think I can reuse this one. Any recommendations for replacement?...

-Front wheel, brake caliper and fork guards off -Loosen top triple clamp bolts and break the caps loose -Remove forks and unscrew the caps the rest of the way -Pull down the fork spring and insert...

The gasket has warped, and don’t fit right in the connector. It’s the throttle body assembly connector....

Any ideas on how to fix this kind of scratch? thought of sanding it down (or even cutting the rough edges with razor blade) and later polish? Is this the best that can be done? Material is almost like...

Last night in a whiskey fuelled decision I decided I was going to take home a large piece of Blue Gum wood to carve into something. In the daylight it was much bigger and heavier than I expected but I...

We jumped back into the hot springs in the morning just to be safe and then rode east. The terrain started to change from desert to grassy meadows and eventually a rainforest by the end of the day....

I woke up feeling a bit seedy from the night before and the bartender who served us beer all night was the same one to cook us breakfast in the morning. We hit the road and our progress was slowed by ...

The Robbery!...

I made it all around Australia without any major wildlife issues and the day after finish I smack a kangaroo at full speed. I was just minding my own business on a remote dirt road North of Morgan whe...

Today we completed the trip around Australia with our return to Angaston where it all began Christmas Day 2012. I put over 20,000 kilometres on the KTM, went through 10 tires, broke countless items, c...

My day began with a cup of coffee and a set of tire irons to change Alicia's front tire....