Front Sprocket Help

The description on the pool page describes what our mission is. so far we have cleaned 4 cemeteries and a public beach/lake spot. very very disturbing how many needles we have picked up so far an kids...

Going to start at the front and work our way back. Up first, fork service and revalve, new brakes, rebuild the caliper, new Tusk DSport front tire, repack front bearings, new fork boots....

Icelandic text But…. ?...

Oil is leaking from the stems. Oil is leaking out from both of these air suspension stems. I read a couple of forums that stated it is either normal or not normal. I can't figure out what the right an...

Refurb'ed and repainted to match the rear and the overall muted colour scheme... Looks good I think....

Got the fromt turn signals done. The turn signal assemblies on this bike are Japanese units. They aren't the same as what is shown in my parts manual, and I believe I must have installed them for so...

  Had some time in the last few days to install the front fender.  I'd previously had the stays rechromed since they had rust spots showing through.  Also replated the stay bracket hard...

Thank you to everyone who has been following along and supporting us! If you didn't win this time, don't lose hope. We will have more in the near future. I'm looking for feedback on what we should t...

Bit more of the annual service completed. Front and rear brakes stripped and cleaned.Front and rear brakes stripped and cleaned....

These stands with wheels are worth their weight in gold... Fantastic! $225.00 on Amazon......

So got a starting and idle issue that's the starting issue that's the idle if you can help in anyway would be much appreciated...

Anyone have tips for removing the front sprocket? I don’t have an air impact and I had the bike almost fall on me trying to crank on it with a breaker bar and someone standing on the rear brake. Alre...

Slightly terrified by what the old one looks like compared to the new... there's barely anything left of the damn thing! No surprise wasn't feeling quite the same power was used to. And yes, changed t...

I broke the bolt because i tried to tighten it without proper tools?. Can i ride with this? Also does anyone have tips on how to remove it without damaging the rest of the spindle?...

The RH front bearing locking cover has a left handed screw so you need to turn it in the opposite direction to normal to get it off. I don't have the special tool required and didn't fancy spending £3...