That seal the housing of the fuel pump to the tank? The OEM kit is expensive and will take a week to delivered....

Even decended Billy Goats Bluff, the steepest track in australia....

Call it labour of love. This is what happens when your adventures reach far beyond Starbucks.?...

Not sure if I'll be tarred and feathered or possibly revered, but this is my solution for the loud open air filter. There is a noticeable difference in noise just putting the plate on and off the top...

My right side clicker is "crunchy" and not as smooth or precise stops as the other side. It's not the damping rod or anything else below, it's the upper clicker assembly as it does it while the top is...

Always a good feeling! Wish they stayed this pretty....

Make sure your filter housing is completely seated (fully clipped in) before reinstalling! Spent way too much time trying to figure what was going on ?...

I know new tires are naturally slick but when they are inflated to nearly 50 psi they're very slick. Luckily this is the brunt of the damage and I'm fine....

Any screw, nut or bolt that falls in here is never seen again!??...

16 45 sprockets fitted, quick test ride and I can't believe the difference it has made. Transformed the bike. Fuel filters next and then a look at the power commander map etc.....

It seems to be a filter. Don’t think I can reuse this one. Any recommendations for replacement?...

-Front wheel, brake caliper and fork guards off -Loosen top triple clamp bolts and break the caps loose -Remove forks and unscrew the caps the rest of the way -Pull down the fork spring and insert...

The gasket has warped, and don’t fit right in the connector. It’s the throttle body assembly connector....

Any ideas on how to fix this kind of scratch? thought of sanding it down (or even cutting the rough edges with razor blade) and later polish? Is this the best that can be done? Material is almost like...