So as many of the world is in lockdown due to this virus, I'm planning on getting some replacement parts for the bike, since I'm not riding as I don't want to take up NHS resources in the event of an ...

I was given this crush washer by the shop but it looks way different than a regular crush washer that I have used on the Hondas. I am going to do the oil change in a couple of days but just wanted to ...

With less than 800 miles on the OE Metzeler Z8 Interact tires, which I really liked, I ran over a piece of steel that left a hole that couldn't be plugged. Originally, I had used a couple of spoons to...

Hello everyone lets get to it. You've been riding and riding and riding and now your rear tire looks like this...

Did some stuff today. Just did front fork seals with the help of a buddy a few weeks ago, and now the oil and tires are done. I love the low mount exhaust, but damn does it make oil changes a mother. ...

Have the new rear tire, sprocket, wheel bearings, brake rotor, and bleed and flushed the rear brake system today. May get the front suspension done today too. It’s mighty cold in the garage today! The...

Front wheel is done. New bearings, Avon 65, and rotors.Goes just as fast as you can push her!...

Got the rear suspension and new rear tire on her...

White Super Fine rouge and Zephyr Pro 40...

This should be hours of pure bliss....

Rear wheel as good as I can get to polish out. The cast aluminum on the spokes and hub are real pain!...

A lot of maintenance to do including fork seals. Going to be lengthy project! But it's worth every single spare minute....

This will make you ill! I don't think sloshing a little bit of fresh petro is going to do any good. If my leg was long enough I'd kick my own ass, That's 8 years worth....

I think many faced with the problem of the lack of a central kickstand of the motorcycle....

As it turned out, the owners of new Honda Rebel CMX 300/500 for 2016-2017 divided into two types: those who have noticed that the speedometer pass water, which later condenses inside, and those who ha...

In every fitting of a new tire, always checking for a straight wheel, good working bearings and a balancing at the end....

After a few weeks I finally went back to work on this girl, I was busy working so I took a few hours off this week to paint the bike, I'm in doubt if I paint Black satin or black matte. Anybody want t...

I was playing on PS I just did it, trying to figure out how it comes with red strip. I think I liked it....

The next time when you change the back brake pads on my motorcycle stuck caliper. And so, step by step, what to do when the wedge caliper. And how to prevent it in the future....