While I was on holiday a package arrived from Bayside Performance. I've been interested in installing a PC5 on my VFR and I finally got around to ordering one. What does it do? It overrides the moto...

Move the bike slowly so as to find the position where chain upper section is more tensioned. Set the motorcycle on the side stand. Measure chain tension at the centre of the lower section, with the...

So, a Desert Sled it is………..or will become....

After the last post I decided that it was worth ordering and fitting a new set of brushes to the starter on the ST2. At less than £10 a set and only an hours job to change them, it made no sense not t...

How cool is this! 1971 Triumph T100R Daytona…………that means twin carb, 500cc little hot rod. The bike showed up at a local shop called “The Daily Rider” in Burlington, VT. It’s a numbers matching examp...

Electronics aren't my strength but I figured out that I could wire a DPDT (Double Pole Double Throw) switch to change modes between the normal restricted mode and the hacked de-restricted mode. W...

Today I took off all of the wiring on the bike. I just had to disconnect all of the wires from their connections and I was done. I had to take the headlight off because all of the wires centralized in...

Remove the tank from the bike Now is a great time to inspect the fuel lines that are attached to the bike....

We started the hike at the altitude of 3950m and we hiked up to 4820m. The entire hike was breathtaking, literally and figuratively ?. The views were astonishingly beautiful. As we are now in the rain...

Note: DO NOT manually operate the SECOND MASTER CYLINDER more than once per operation of the rear brake pedal. Continuously pushing in the SECOND MASTER CYLINDER numerous times will not blee...

Today I took the fenders off of the bike. I set up the bike in the driveway and proceeded to unscrew tons of nuts and bolts to get parts off. The front fender came off with no problem. However, the ba...

Can't tell if the tank itself is actually flaking or if it's a coat that's flaking off? What would you recommend doing from here?...

Remove the cap to expose the bleed valve (3). Connect a clutch circuit bleeding tool to the clutch slave cylinder bleed valve (3). Remove the cover (1) with the membrane from the clutch fluid reservo...

Have a 2022 SAS for about 10 months now. 100 % road while daily commuting. I do use the engine ? , but never did any funny stuff (wheelies or burn outs). The wear is only on one side (wires exposed),...

Clutch fluid is corrosive and will damage paint. Avoid contact with eyes and skin. In case of accidental contact, wash thoroughly with water. Fill the reservoir with specified fluid taken from a...