After removing the cable, the default position is open or closed under spring tension? Anyone know for certain?...

What connector connects to the kick stand sensor. I sent mine to a shop and it came back without the sensor. Just need a little guidance on with connector is used for it so I can just bypass it....

Rio Douro, Portugal...

This past weekend in a little sentence: skies were clear, roads were travelled, fun was had and a cow was photographed?...

Recently started noticing in 2nd gear and 3rd gear at higher rpms get vibrations through my foot pegs and seat. I'm not sure If this has always been there or not, just had a new rear tire put on at a...

Cleaned and Painted...

I just pulled it easily from inside on the left side near the clutch slave. The end was pointed to the ground and not attached...

The bottom half of the motor is mounted into the bike. This will help when trying to assemble the top half because it means I don't have go continually chase around the bottom half. It is rigidly moun...

After studying forums and talking with other "sufferers," several options emerged: - Ignore it (Not for me) - Buy a factory hose (with thermal insulation included) - DIY...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

After almost 4 years I finally bit the bullet one night and ordered the Honda genuine accessory heated grips and 12V accessory harness. They were expensive.... 3 or 4 times the price of comparable aft...

This is quite an increase from stock but I am reducing the seat height by at least half so I think this evens out on balance... Here is the swing arm with my 375 mm bespoke Hagon shockers (I may well...

I'm changing out my chain and sprockets to a 520 conversion but I'm not sure which way the front sprocket faces. How can I measure which way it faces with one side having a shoulder and not the other?...

Rear caliper NISSIN but not from VFR(...

Continuation of the VFR resurrection story Gradually started cleaning the parts. The swingarm turned out to have a significant wear mark due to a makeshift footpeg bracket. BEFORE:...

I've loudly sung the praises of Shorai LFX Lithium Iron Phosphate batteries in my VFR blog and elsewhere so it seemed automatic that I'd have one for my GB. Compared to the messy old vented...