The next part of my creative work in the form of a beaten-up sport bike :)...

I was driving home from work when I heard a loud snap, followed by a new loud ticking sound. Thinking the chain snapped or something, gave it some gas to check and nope still had power, peeked under t...

The stuff…..all the electronics came from the guys at The Factory Metal Works. Pazon electronic ignition, twin lead 12 volt coil, and Boyer battery eliminator....

It was just a boring run home from work not warp factor 10...

?...

After removing the cable, the default position is open or closed under spring tension? Anyone know for certain?...

What connector connects to the kick stand sensor. I sent mine to a shop and it came back without the sensor. Just need a little guidance on with connector is used for it so I can just bypass it....

Rio Douro, Portugal...

This past weekend in a little sentence: skies were clear, roads were travelled, fun was had and a cow was photographed?...

Recently started noticing in 2nd gear and 3rd gear at higher rpms get vibrations through my foot pegs and seat. I'm not sure If this has always been there or not, just had a new rear tire put on at a...

Cleaned and Painted...

I just pulled it easily from inside on the left side near the clutch slave. The end was pointed to the ground and not attached...

The bottom half of the motor is mounted into the bike. This will help when trying to assemble the top half because it means I don't have go continually chase around the bottom half. It is rigidly moun...

After studying forums and talking with other "sufferers," several options emerged: - Ignore it (Not for me) - Buy a factory hose (with thermal insulation included) - DIY...

I just got my new tire mounted and balanced and ended up cleaning the chain too. I didn't notice till after cleaned the rim that two wheel weights had fallen off and I can't find any residue to figure...

After almost 4 years I finally bit the bullet one night and ordered the Honda genuine accessory heated grips and 12V accessory harness. They were expensive.... 3 or 4 times the price of comparable aft...

This is quite an increase from stock but I am reducing the seat height by at least half so I think this evens out on balance... Here is the swing arm with my 375 mm bespoke Hagon shockers (I may well...