It took me a long time to buy this bike, and I never thought I would buy a Golda. At different ages there were different reasons why not - starting from the old age of the oppositions and ending it on...

Hello everyone, quick question: Can these Brake pads still be used? Bike is a Honda CBR 600RR and these are from the back brake calliper. just did new ones in the front (all 4 of them). Do these also...

It took me on a tour of Europe that summer and fall from England to Istanbul, and back to Northern Germany, where I put it on a ship back to the states. A few weeks later, I picked it up in New Jerse...

The folks at Rebel Gears delivered big time on service, knowledge, and product! I received my 56 tooth overlay sprocket today....

You need 12 off 17mm x 6mm Dzus fasteners and 12 slip on clips. D8 are the better machined fasteners. Available in crosshead , allen hex or D tab for hand removal. 3 along the top of the mi...

The piston I ordered is technically a piston for a BSA, however, it will work for my bike perfectly. I needed a +.020 piston (20 over the original production size piston) because as the piston goes up...

The bigger the bore, the softer the engagement. It should improve the function a lot....

The pac-man Leo Vince sticker looked a little nerdy so I peeled it off with the help of an old hair dryer and some acetone to clean up the glue....

??...

R1 Parts Required (all other parts are re-usable)  - Forks - Upper Triple Clamp - Lower Triple Clamp...

This is a step by step video including torque specs....

Shank Diameter Also called Major diameter. The diameter of a bolt is the Shank diameter, expressed in millimetres for Metric bolts. Because this is approximately the same as the Major or Thread diame...

DIY Bates Desert Racer Seat...

  An insecure part of me worried that the bike wouldn't be there when I opened the door to the 5x10 storage locker...

Hopefully re-fit the rear wheel, rear brake tomorrow...

Summary: My charging system diagnosis procedure, modified over time to generally point out the problem through a series of steps. I try to follow it every time, as that way I don’t miss anything...

Any screw, nut or bolt that falls in here is never seen again!??...