We started the hike at the altitude of 3950m and we hiked up to 4820m. The entire hike was breathtaking, literally and figuratively ?. The views were astonishingly beautiful. As we are now in the rain...

Note: DO NOT manually operate the SECOND MASTER CYLINDER more than once per operation of the rear brake pedal. Continuously pushing in the SECOND MASTER CYLINDER numerous times will not blee...

Today I took the fenders off of the bike. I set up the bike in the driveway and proceeded to unscrew tons of nuts and bolts to get parts off. The front fender came off with no problem. However, the ba...

Can't tell if the tank itself is actually flaking or if it's a coat that's flaking off? What would you recommend doing from here?...

Remove the cap to expose the bleed valve (3). Connect a clutch circuit bleeding tool to the clutch slave cylinder bleed valve (3). Remove the cover (1) with the membrane from the clutch fluid reservo...

Have a 2022 SAS for about 10 months now. 100 % road while daily commuting. I do use the engine ? , but never did any funny stuff (wheelies or burn outs). The wear is only on one side (wires exposed),...

Clutch fluid is corrosive and will damage paint. Avoid contact with eyes and skin. In case of accidental contact, wash thoroughly with water. Fill the reservoir with specified fluid taken from a...

Began to notice my Spiegler Black Synto brake and clutch levers were turning purple. They were just a few years old so, I contacted the company. They agreed to replace the defective product with a sil...

Inward (behind) the choke knob is an adjuster under the rubber cap. ...

The piston I ordered is technically a piston for a BSA, however, it will work for my bike perfectly. I needed a +.020 piston (20 over the original production size piston) because as the piston goes up...

Not only does this common wear service item cause vacuum leaks, it allows fuel to leak as well. This one was found to not shut off fuel when no vacuum was applied (engine off) The diaphragm has...

?...

I found a parts manual online that has diagrams of all of the different parts on the motorcycle and where they go.The manual shows a bike that is the same model as mine but it is 2 years older than my...

You need 12 off 17mm x 6mm Dzus fasteners and 12 slip on clips. D8 are the better machined fasteners. Available in crosshead , allen hex or D tab for hand removal. 3 along the top of the mi...

There are many opinions about the defective tire. I decided to check the wheel runout. I know - it's not very professional to write it, but I gathered some information. Rim +/- 0.2 mm Tire edge +/- 0....

The Rocker Box had to come off first. We figured out that most of the bike uses Whitworth which is a British standard hardware. This is no longer used but since my bike was from 1970 they still used t...